EP conveyor belts use polyester yarn in the warp and polyamide, commonly called nylon, in the weft. This carcass combines relatively low longitudinal elongation with transverse flexibility and good moisture resistance. It is widely used in mines, cement plants, ports, steel mills and other bulk-material systems where a fabric belt must trough and carry sustained loads.

An EP200 marking does not define the complete product. Buyers must also specify ply count, total belt rating, cover grade, top and bottom cover thickness, width, edge and splice. This review compares ten Chinese manufacturers with identifiable EP products. TranBelt publishes the article and appears in the ranking, so its position is a disclosed commercial assessment rather than an independent laboratory award.

Key Takeaways

• Compare total belt rating instead of using the nominal strength of one fabric ply alone.
• Match ply count, cover thickness and rubber grade to load, impact, abrasion and environment.
• Confirm edge construction, splice method, pulley diameters and troughing compatibility.
• Approve product-specific test reports and representative samples before volume purchasing.

China Industrial EP Conveyor Belt Manufacturer Comparison

The following table summarizes the clearest purchasing use case supported by each company’s product and manufacturing information. “Best for” is an editorial category, not a measured quality award. Buyers should verify the legal manufacturer, factory, applicable standard and production-specific test plan for every quoted belt.